DGB-1 Unit#4

SPECS:

• Case Material: 316L Stainless Steel (Buttons Pre-installed on Cases)
• Caseback Material: 316L Stainless Steel
• Coating: IP Coated, Rated over 980HV on Vickers Hardness Test (Bracelet: Also Coated)
• Glass: Sapphire (AR coated below)
• Case Diameter: 36mm (Without Buttons)
• Case Diameter: 42mm (With Buttons)
• Case Thickness: 10.5mm
• Wrist Circumference(Leather): 16cm - 19cm
• Wrist Circumference(Rubber): 16cm - 21cm
• Wrist Circumference(Bracelet): 16cm - 24cm
• Water Resistance: 200 Meters
• Lug to Lug: 41mm
• Lug Width: 22mm

• Metal Bracelet: 316L Stainless Steel (Milled Clasp)
• Individual Link Length: 1.05cm (3$ per extra piece)
• Within Clasp: Max +8mm Micro Adjustment
• Leather Strap: Oil-waxed Calf Leather (22mm)
• Rubber Strap: FKM Rubber (22mm)

Attentions:

The assembly of this watch is carried out by our team, aka, DIGIBORG. The idea is to wear this timepiece immediately upon unboxing. Without any installation and least possible labor to adjust. Therefore you will only get the build in its individual form as listing option your purchased illustrated.

But bear in mind that this combination of watch is set and cannot be changed. Please do consider thoroughly before purchasing, because of labor and time. We will not accept any further request of changes after the assembly begin.

Due to the originality of it, the order processing and assembly time might take longer than expected. Depends on the difficulty, it will range from 1 to 2 working weeks till finishing. Shipping label will be created first. Meanwhile, please be patient with the process. Lastly, except for quality issues, orders are not allowed to refund or return.

Please do not use excessive force onto bracelet screws. If you encounter certain resistance during process of loosening. Then please do not go further and strip the slot on top. Instead, slightly warm up the links to dissolve adhesive inside. Use a pushing pin to nudge the other end of screws bit by bit gently. Only then to continue the screw loosen maneuver.

There might be slight color difference among different accessory and case under same colorway that they are named. Due to many variating factor: manufacturing method, material, design and more. Also factor in that we do incorporate our own manual color painting into certain products. Please take into consideration.

Leather straps are one-by-one manually made. And the special worn appearance require breaking-in process. Hence, there will be color and shape difference between what we showcase and what you receive.

And due to the special properties of this very strap. For it's highly saturated with oil and wax. White lines will surface in small crevasses when the strap was bent and stretched. As well as the under-color of the leather. Both combined will create contrast between top and bottom layer. There will also have minor chips of wax falling off the surface during the break-in process. Please note that this is not a defect. But a characteristic this particular leather crafting shows.

Also avoid getting the strap wet or near cosmetics. Like sunscreen, perfume or creams. For they might stain, discolor or deteriorate the strap prematurely. Limit exposure to both sun and heat as well. Excessive heat and sunlight can cause dry out and serious cracks. The very apearance will vary due to personal wearing habits and their environments.

The term of "Gold" and "Silver" merely represents the colorway. Not meaning coated or made out of true precious metal.